AMPLIFICATORE FINALE STEREO CLASSÈ CA-D200
Finale di potenza a 2 canali ad alta corrente. 2 x 200W su 8 ohm, 2 x 400W su 4 ohm. Stadi finali in claase D. Alimentazione switching. DSP proprietario per l’analisi in tempo reale delle condizioni di funzionamento e della potenza erogata. Ingresso RCA e XLR. RS-232. Trigger IN/OUT. Controllo IR IN/OUT. RJ45 per bus dati.
CA-D200 200W STEREO AMPLIFIER
All tests un-weighted and 500kHz measurement bandwidth (except SNR). | ||
Frequency response | 10 Hz – 20 kHz, -1 dB into 4Ω | |
Output power | 200W/Ch rms into 8Ω (14.5dBW) | |
Harmonic Distortion | <0.018% @ 1kHz Balanced Input | |
Peak Output Voltage | 113V peak to peak, 40V RMS no load | |
Input Impedance | 100kΩ Balanced / 50kΩ SE | |
Voltage gain | 29 dB | |
Input level at clipping | 1.4V rms Balanced/SE | |
Intermodulation | >80 dB below fundamental | |
Signal to Noise Ratio | -100 dB at peak output into 8Ω | |
Mains Voltage | 90-264V, 50/60 Hz | |
Standby power | 3W @ 120V; 4W @ 230V | |
Dimensions | Width 17.5” (445mm)(excluding connectors) | |
Weight | 28lb (12.7kg) Net | |
